8/10/2023 0 Comments Distilling with anvil foundry![]() ![]() However, on cold days, it's nice to have the option to take operations indoors. Until recently, I've used a decked out 10 gallon Spike Brewing Kettle on a propane burner, which works just fine. I've had my eye on all in one systems for brewing both extract and all grain recipes for some time now. I would recommend the base system to a friend with the thought that they buy a better pump system. Cleanup was relatively easy, but complicated by the systems height and the fact that you have to be careful of the electronics around the sink. (And not be yet another small part I have to keep track of.) The pump works well, it could just be better with some tweaks. A tedious and messy set of steps I would not have to do if I had a pump that could handle the boiling wort temps. I did that, then pumped some starsan through the tubing and pump head to sanitize it so I could pump the wort into my fermentor after it had been cooled down. Some of the wort will therefore stay in the lines unless you remove the pump after the mash and drain it. Because of this, instructions explicitly state not to use it for pumping boiling wort. The pump head and it's guts are all plastic. My only issue with the system so far is the pump. (Still better then manually maintaining temps!) I plan on running a 220 outlet soon so it should work even faster. It did notice that it overshot the mash temp at times by a couple degrees. And kept the temp within a few degrees of my target mash temp easily. The brewing system worked great! I only have 110V outlets in my brew area but even then it came up to temp in a reasonable time frame.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |